Copyright © 2000, 2001, 2002, 2003 by The FreeBSD Documentation Project
This is a preliminary document. It is incomplete, and in need of additional content. Please send additional information on IA-64 processors, motherboards, and various devices working on FreeBSD to the FreeBSD IA64 porting mailing list.
This document contains the hardware compatibility notes for FreeBSD 5.1-RELEASE on the IA-64 hardware platform (also referred to as FreeBSD/ia64 5.1-RELEASE). It lists devices known to work on this platform, as well as some notes on boot-time kernel customization that may be useful when attempting to configure support for new devices.
Note: This document includes information specific to the IA-64 hardware platform. Versions of the hardware compatibility notes for other architectures will differ in some details.
More information on FreeBSD/ia64 is contained on the FreeBSD/ia64 Project page.
Currently supported processors are the Itanium and the Itanium 2.
Supported chipsets include:
HP zx1 (only on development branch, see the Perforce repository)
HP i2000
Intel 460GX
Intel E8870
Both Uniprocessor (UP) and Symmetric Multi-processor (SMP) configurations are under active development. At this time, SMP-enabled systems are considered less stable. The current priorities are UP fixes to improve stability.
This section contains additional information about what devices may or may not be supported by FreeBSD/ia64.
Except for the PC chipset embedded ata(4) controllers, most should work out of the box. Eventually, all ia64-compatible ATA controllers are expected to be fully supported. Refer to the following sections for various disk controllers and their current status.
In general, ``PC standard'' serial ports supported by the sio(4) driver are expected to work on Intel legacy machines, but not PA legacy machines. The reason is that all devices on HP machines are memory-mapped and there is no ISA device support other than the PCI dictated VGA legacy.
In addition to sio(4) devices, the following devices fail on non-Intel legacy machines (but should work on boxes with an Intel legacy) because their drivers make ISA-specific assumptions that do not hold:
| sio(4) | No support for memory-mapped I/O |
| syscons(4) | Expect BIOS, VGA probes, etc. |
| pcm(4) | Probes MSS ISA ports ad nauseum |
| atkbd(4), psm(4) | Fixed ISA port locations |
This section describes the devices currently known to be supported by with FreeBSD on the IA-64 platform. Other configurations may also work, but simply have not been tested yet. Feedback, updates, and corrections to this list are encouraged.
Where possible, the drivers applicable to each device or class of devices is listed. If the driver in question has a manual page in the FreeBSD base distribution (most should), it is referenced here.
IDE/ATA controllers ( ata(4) driver)
Acard ATP850 UDMA2, ATP860 UDMA4, ATP865 UDMA6
AMD 756 ATA66, 766 ATA100, 768 ATA100
Cenatek Rocket Drive
CMD 646, 648 ATA66, and 649 ATA100
Cypress 82C693
Cyrix 5530 ATA33
HighPoint HPT366 ATA66, HPT370 ATA100, HPT372 ATA133, HPT374 ATA133
Intel PIIX, PIIX3, PIIX4
Intel ICH ATA66, ICH2 ATA100, ICH3 ATA100, ICH4 ATA100
nVidia nForce ATA100, nForce2 ATA133
Promise ATA100 OEM chip (pdc20265)
Promise ATA133 OEM chip (pdc20269)
Promise Fasttrak-33, -66, -100, -100 TX2/TX4, -133 TX2/TX2000
Promise SATA150 TX2/TX4 Serial ATA/150
Promise Ultra-33, -66, -100, -133 TX2/TX2000/TX4000
ServerWorks ROSB4 ATA33
ServerWorks CSB5 and CSB6 ATA66/ATA100
Sil 0680 UDMA6
SiS 530, 540, 550, 620
SiS 630, 630S, 633, 635, 640, 645, 645DX, 648, 650, 651, 652, 655, 658, 730, 733, 735, 740, 745, 746, 748, 750, 751, 752, 755
SiS 5591 ATA100
VIA 82C586 ATA33, 82C596 ATA66, 82C686a ATA66, 82C686b ATA100
VIA 8233, 8235 ATA133
Qlogic controllers and variants ( isp(4) driver)
Qlogic 1020, 1040 SCSI and Ultra SCSI host adapters
Qlogic 1240 dual Ultra SCSI controllers
Qlogic 1080 Ultra2 LVD and 1280 Dual Ultra2 LVD controllers
Qlogic 12160 Ultra3 LVD controllers
Qlogic 2100 and Qlogic 2200 Fibre Channel SCSI controllers
Qlogic 2300 and Qlogic 2312 2-Gigabit Fibre Channel SCSI controllers
Performance Technology SBS440 ISP1000 variants
Performance Technology SBS450 ISP1040 variants
Performance Technology SBS470 ISP2100 variants
Antares Microsystems P-0033 ISP2100 variants
LSI Logic Fusion/MP architecture Fiber Channel controllers (mpt driver)
LSI 53c1020, 53c1030
With all supported SCSI controllers, full support is provided for SCSI-I, SCSI-II, and SCSI-III peripherals, including hard disks, optical disks, tape drives (including DAT, 8mm Exabyte, Mammoth, and DLT), medium changers, processor target devices and CD-ROM drives. WORM devices that support CD-ROM commands are supported for read-only access by the CD-ROM drivers (such as cd(4)). WORM/CD-R/CD-RW writing support is provided by cdrecord(1), which is a part of the sysutils/cdrtools port in the Ports Collection.
The following CD-ROM type systems are supported at this time:
SCSI interface (also includes ProAudio Spectrum and SoundBlaster SCSI) ( cd(4))
ATAPI IDE interface ( acd(4))
Intel 82557-, 82258-, 82559-, 82550- or 82562-based Fast Ethernet NICs ( fxp(4) driver)
Intel EtherExpress Pro/100B PCI Fast Ethernet
Intel InBusiness 10/100 PCI Network Adapter
Intel PRO/100+ Management Adapter
Intel Pro/100 VE Desktop Adapter
Intel Pro/100 M Desktop Adapter
Intel Pro/100 S Desktop, Server and Dual-Port Server Adapters
On-board Ethernet NICs on many Intel motherboards.
Gigabit Ethernet NICs based on the Broadcom BCM570x ( bge(4) driver)
3Com 3c996-SX, 3c996-T
Netgear GA302T
SysKonnect SK-9D21 and 9D41
Gigabit Ethernet NICs based on the Intel 82542 and 82543 controller chips ( gx(4) and em(4) drivers), plus NICs supported by the Intel 82540EM, 82544, 82545EM, and 82546EB controller chips ( em(4) driver only)
Intel PRO/1000 Gigabit Ethernet
Note: The em(4) driver is officially supported by Intel, but is only supported on the i386.
``PC standard'' 8250, 16450, and 16550-based serial ports ( sio(4) driver)
PCI-Based multi-port serial boards ( puc(4) driver)
Diva Serial (GSP) Multiport UART (development branch only)
Host Controllers ( ohci(4) and uhci(4) drivers)
UHCI or OHCI compliant motherboard chipsets (no exceptions known)
USB 2.0 controllers using the EHCI interface ( ehci(4) driver)
VGA-compatible video cards ( vga(4) driver)
Note: Information regarding specific video cards and compatibility with XFree86 can be found at http://www.xfree86.org/.
Keyboards including:
PS/2 keyboards ( atkbd(4) driver)
Pointing devices including:
PS/2 mice and compatible devices, including many laptop pointing devices ( psm(4) driver)
Serial mice and compatible devices
Note: moused(8) has more information on using pointing devices with FreeBSD. Information on using pointing devices with XFree86 can be found at http://www.xfree86.org/.
This file, and other release-related documents, can be downloaded from ftp://ftp.FreeBSD.org/.
For questions about FreeBSD, read the documentation before contacting <[email protected]>.
All users of FreeBSD 5-CURRENT should subscribe to the <[email protected]> mailing list.
For questions about this documentation, e-mail <[email protected]>.